Metra Electronics Car Stereo System 99 9305 User Manual

INSTALLATION INSTRUCTIONS FOR PART 99-9305  
APPLICATIONS  
BMW X3  
2004-2010  
(NON-NAV MODELS)  
99-9305  
KIT FEATURES  
• ISO DIN Head Unit Provision  
KIT COMPONENTS  
A) Radio Housing • B) ISO Brackets • C) (4) Phillips Screws • D) (4) Phillips ISO Screws  
L
D
C
R
WIRING AND ANTENNA CONNECTIONS  
(Sold Separately)  
• 40-EU10 - European antenna adapter  
• 70-9003 - European wire harness  
B
A
TOOLS REQUIRED:  
Flat Blade Screwdriver • Phillips Screwdriver • Drill  
1-800-221-0932  
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION  
 
DASH DISASSEMBLY  
99-9305  
BMW X3 2004-2010  
(NON-NAV MODELS)  
A
Disconnect the negative battery  
terminal to prevent an accidental  
short circuit.  
1
2
Unclip and remove the hazard/door  
lock switch. (Figure A)  
Unclip and remove the a/c vents  
above the radio. ( Figure B)  
3
4
Remove (2) Phillips screws on top of  
the radio/climate control panel fac-  
ing down. (Figure C)  
B
Unclip and remove the radio/climate  
control panel. (Figure D)  
5
6
Remove (2) Phillips screws securing  
the radio. (Figure D)  
D
C
1
 
KIT ASSEMBLY  
99-9305  
ISO DIN HEAD UNIT PROVISION  
A
Secure the corresponding bracket to  
1
the aftermarket radio using the  
hardware supplied with the radio.  
(Figure A)  
NOTE: If the ISO screws supplied with  
the aftermarket radio are too big, use  
the supplied (4) Phillips ISO screws.  
Using a drill screw the radio/bracket  
assembly into the dash using the  
supplied (4) Phillips screws. (Figure B)  
2
3
B
Position the radio housing over the  
radio face and secure using the fac-  
tory hardware. (Figure C)  
C
2
 
FINAL ASSEMBLY  
99-9305  
FINAL ASSEMBLY  
Locate the factory wiring harness in the dash and make the connection as shown.  
Metra recomends using the proper mating adapter and making the connections as  
shown. (Isolate and individually tape off the ends of any unused wires to prevent  
electrical short circuit.)  
1
Re-connect the negative battery terminal and test the unit for proper operation.  
Reassemble radio and dash assemblies in reverse order of disassembly.  
2
3
FINAL WIRING CONNECTIONS  
Make wiring connections using the EIA color code chart shown below and the instructions included with the head  
unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually  
tape off ends of any unused wires to prevent electrical short circuit.  
A
A)  
B)  
C)  
D)  
Strip wire ends back 1/2"  
Twist ends together  
Solder  
B
C
Tape  
D
METRA / EIA WIRING CODE  
12V Ignition / Acc . . . Red  
Right Front (+) . . . . . Gray  
12V Batt / Memory . . Yellow  
Ground . . . . . . . . . . . Black*  
Power Antenna . . . . . Blue  
Right Front (-). . . . . . Gray / Black  
Left Front (+) . . . . . . White  
Left Front (-). . . . . . . White / Black  
Right Rear (+). . . . . . Violet  
Amp Turn-On . . . . . . Blue / White  
Amp Ground . . . . . . . Black / White  
Illumination. . . . . . . . Orange  
Dimmer . . . . . . . . . . Orange / White  
Right Rear (-) . . . . . . Violet / Black  
Left Rear (+). . . . . . . Green  
Left Rear (-) . . . . . . . Green / Black  
*NOTE: When Black a wire is not present, ground radio to vehicle chassis.  
All colors may not be present on all leads due to manufacturer’s specifications.  
3
 
99-9305  
NOTES  
4
 
99-9305  
NOTES  
5
 
99-9305 INSTRUCTIONS  
1-800-221-0932  
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION  
INST99-9305  
REV. 04/26/09  
 

Krown Manufacturing Telephone 082 User Manual
LG Electronics Cell Phone 600 User Manual
LG Electronics Clothes Dryer P154 User Manual
Linn Stereo Amplifier Klout User Manual
Magnavox CRT Television MS3252S MS3652S User Manual
Marantz Garage Door Opener VC 8100 User Manual
Marshall electronic Computer Monitor V R151PV R151P User Manual
McCulloch Blower MAC GBV 345 User Manual
Metra Electronics Automobile Accessories 99 3306 User Manual
Metrologic Instruments Barcode Reader IS1000 User Manual